ATI 918464 Honda S2000 F20/F22 Street Super Damper — 5.670 in
ATI Dampers
MPN: ATI918464
Price: $366.99 USD
Purchase details
Out of stock
Fitment
Fitment notes
- Application: 2000–2009 Honda S2000 F20/F22
Description
ATI 918464 Super Damper uses a 5.670-inch aluminum shell, steel hub and three inertia rings to control torsional crankshaft vibration.
The six-rib accessory drive runs 7% over the factory ratio. ATI lists a 600 hp maximum application rating, laser-etched timing marks and SFI 18.1 certification.
Specifications
| Manufacturer part number | ATI918464 |
|---|---|
| Manufacturer part number | 918464 |
| Outer diameter | 5.670 in |
| Shell | aluminum; three inertia rings |
| Hub | steel, 916127 |
| Accessory drive | six ribs; 7% overdrive |
| Maximum application rating | 600 hp |
| SFI specification | 18.1 |
Install & Results
Install & Results
Confirm crankshaft fit, belt alignment and clearance during installation.
ATI Super Damper installation instructions
Have the damper installed by a qualified engine technician. Inspect the crank snout, key and hub, measure the crank and hub to verify the required fit, and follow ATI's press-fit instructions. Use a proper damper installation tool; do not hammer the damper on. Confirm the hub is fully seated, align the shell and hub indexing marks where applicable, and use the specified fasteners and tightening procedure. Tighten the crank bolt and washer to the engine manufacturer's specification unless the exact damper instructions state otherwise. Check pulley alignment, belt tension and clearance. Confirm the six-rib belt arrangement and 7% accessory overdrive for the build. Use the street assembly's instructions and hardware.